XO8085-010SR 100.000000

MtronPTI XO8085 Integrated Frequency References Combining over 25 years of discrete RF design expertise and high precision OCXO manufacturing experience, MtronPTI’s XO8085 series provides designers a High Stability, Ultra Low Phase Noise and Low G-Sensitivity PLL OCXO platform with an option of Multi Output Frequency References. With RF systems getting smaller in size an integrated assembly like XO8085 with multi output frequency references, enable system designers to employ one small package with multi frequency references versus multiple OCXOs saving SWaP, cost and improving reliability. For a 100MHz OCXO phase locked to a lower frequency references like a 10MHz OCXO, the close-in phase noise of the output is determined by the low frequency reference and the phase noise of offset frequencies greater than the PLL bandwidth is determined by the locked RF oscillator (100MHz OCXO). The XO8085 series provides a noise floor approaching -180dBc/Hz and close-in performance of -130dBc/Hz or better at 100Hz offset Features: SWaP, Multi-Output Options, High Stability, Ultra Low Phase Noise, Low g-sensitivity Applications: Test and Measurements, Radar Systems, Satcom, Avionics General & Electrical Requirements: A]. 10MHz Reference Input and 100MHz Output Parameter Nominal Frequency (RF Output) Symbol FO Min. Typ. 100.0000 Max. Units MHz Conditions Frequency Stabilities vs. Temperature 1 ∆FT/F vs. Supply voltage1 variation Daily Aging1 1 Year Aging1 20-Years Aging1 -100 +100 ppb -30 +30 ppb -5 -0.5 -1.0 +5 +0.5 +1.0 ppb ppm ppm Over the Operating Temperature Range 5% change in supply voltage After 30-days Power On Page 1 of 4 The information contained herein is proprietary to MtronPTI and is submitted in confidence. This information may not be copied or divulged without the express written permission of MtronPTI MtronPTI XO8085 Integrated Frequency References RF External Reference (10MHz) -3 0 +3 RF Input Level RF Input Lock Range +/- 1 dBm ppm Customer to choose the signal Level between 0+/3dB 10MHz External would need to be within +/- 1ppm from Nominal 10MHz to lock RF Output(100MHz) Sinewave Output Type Output Level +13 Output Load dBm 50 Additional Parameters -100 -130 -158 -175 -180 -180 -180 -30 -50 -80 1 Phase Noise (Under Static Conditions) Harmonics Sub-Harmonics Spurious g-sensitivity Warm-up Time 5 Ω dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz dB dB dB ppb/g minutes ±10% 10Hz Offset 100Hz Offset 1kHz Offset 10kHz Offset 100kHz Offset 1MHz Offset 10MHz Offset Worst case axis Test Condition(@ 25°C): Oscillator turned ON after 24hrs OFF. Frequency change 5 minutes after turn ON will be within ±0.05ppm of Long-term stable nominal frequency. Temperature, Supply Voltage & Power Consumption Operating Temperature OTR -40 Storage Temperature Operating Voltage STR VCC -55 +4.75 +70 +5.0 1.5 +100 +5.25 ° C ° VD Full Specification Compliance Steady state @ 25°C, In Still Air 4.0 Watts @ Warm-up 1 Typical frequency stability parameters, performance will be representative of the 10MHz ref. that customer will feed on pin-15 Power Consumption Environmental Conditions: Seal RoHS Watts Hermetic Full RoHS Compliance Page 2 of 4 The information contained herein is proprietary to MtronPTI and is submitted in confidence. This information may not be copied or divulged without the express written permission of MtronPTI MtronPTI XO8085 Integrated Frequency References RF Input: 10MHz (External reference) Fault Indicator: 3.3 in Lock; 0V Out of Lock Note: Thru-hole option available. B]. 10MHz Reference Input and Four 100MHz Outputs Parameter Nominal Frequency vs. Temperature vs. Supply voltage variation Daily Aging 1 Year Aging 20-Years Aging RF Input Level Output Type (Four Ports) Symbol FO Min. Typ. Max. 100.0000 Frequency Stabilities ∆FT/F -100 +100 ppb -30 +30 ppb -5 +5 -0.5 +0.5 -2.0 +2.0 RF External Reference (10MHz) -3 0 +3 Units MHz ppb ppm ppm dBm RF Outputs(100MHz) Sinewave Conditions Over the Operating Temperature Range 5% change in supply voltage After 30-days Power On Customer to choose the signal Level between 0+/3dB On Port 1 , Port2 , Port 3 and Port 4 simultaneously Output Level 7 dBm Output Load 50 Ω On Port 1 , Port2 , Port 3 and Port 4 simultaneously ±10% Page 3 of 4 The information contained herein is proprietary to MtronPTI and is submitted in confidence. This information may not be copied or divulged without the express written permission of MtronPTI MtronPTI XO8085 Integrated Frequency References Port Isolation Output VSWR 30 dB 1.5:1 Additional Parameters -105 Phase Noise (Under Static Conditions) -130 -158 -167 -170 -170 0.3 -25 -75 G-sensitivity Harmonics Spurious Warm-up Time 5 Operating Temperature Storage Temperature Operating Voltage Power Consumption Datasheet Revision Table: Date Rev. 06-08-18 A Orig. DPD dBc/Hz 10Hz Offset dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz ppb/g dB c dB c minutes 100Hz Offset 1kHz Offset 10kHz Offset 100kHz Offset 1MHz Offset By design Temperature, Supply Voltage & Power Consumption OTR -40 +80 ° C STR -55 +100 ° C VCC V +4.75 +5.0 +5.25 D 1.5 Watts 4.0 Watts To within ±0.1ppm of the frequency after 1-hour of operation @ 25°C Full Specification Compliance Steady state @ 25°C, In Still Air @ Warm-up Details of Revision Original Draft Page 4 of 4 The information contained herein is proprietary to MtronPTI and is submitted in confidence. This information may not be copied or divulged without the express written permission of MtronPTI